Share To:

In this note, Poly Notes Hub shares a Diploma Engineering Notes on a Topic called “How to Use Buzzer with Arduino?” or “Arduino With Buzzer“.

Author Name: Arun Paul.

Table of Contents

About Buzzer

What is Buzzer?

In Arduino projects, a buzzer or piezo speaker is a simple and effective component that can generate audible tones and sounds. A buzzer may provide your electronic inventions with an audible element, whether you want to use it to make beeps, alarms, or tunes. We’ll look at connecting and managing a buzzer with an Arduino microcontroller in this lesson.

Types of Buzzers

There are five types of Buzzer as follows:

Piezoelectric Buzzers
Magnetic Buzzers

Electromagnetic Buzzers
Mechanical Buzzers
Electromechanical Buzzers

Applications of Buzzer

Buzzers are used in

Automotives
Trains

Alarm systems
Timers etc.

How to Use Buzzer with Arduino?

Introduction

A buzzer is a small but powerful device that can make your projects beep, sing, or even play music. By following the steps in this article, you’ll learn how to connect a buzzer to your Arduino, write simple code, and create your very own tunes. It’s a fun and engaging way to add another layer of creativity to your projects. We are using three buzzers with Arduino in this project.

Components

We will need these components to do this project.

Three Buzzers
Jumper Wires

Three 100 ohm Resistors
Arduino Board
USB cable

Circuit Diagram of Arduino with Buzzer

Below shows the hardware and circuit connection on this topic.

Click Here for More Notes

Code

int pos = 0;

void setup()
{
  pinMode(8, OUTPUT);
  pinMode(6, OUTPUT);
  pinMode(7, OUTPUT);
}

void loop()
{
  // turn off tone function for pin 8:
  noTone(8);

  // play a note on pin 6 for 200 ms:
  tone(6, 880, 200); // play tone 69 (A5 = 880 Hz)
  delay(200); // Wait for 200 millisecond(s)

  // turn off tone function for pin 6:
  noTone(6);

  // play a note on pin 7 for 500 ms:
  tone(7, 988, 500); // play tone 71 (B5 = 988 Hz)
  delay(500); // Wait for 500 millisecond(s)

  // turn off tone function for pin 7:
  noTone(7);

  // play a note on pin 8 for 300 ms:
  tone(8, 1047, 300); // play tone 72 (C6 = 1047 Hz)
  delay(300); // Wait for 300 millisecond(s)
}

Conclusion | Diploma Engineering Notes | Poly Notes Hub

In this note, we discuss How to use buzzer with Arduino. Our Poly Notes Hub provides syllabus-wise notes for polytechnic or diploma engineering students of streams like Electrical Engineering, Electronics and Telecommunication Engineering, Electrical and Electronics Engineering, Electronics & Instrumentation Engineering, and Computer Science & Technology. Our website is updating daily so please keep in touch with us for new and syllabus-wise notes and topic which helps you all to do any task related to diploma engineering.